Rago Fabrication Lexus GX 470 and 5th Gen 4Runner Relay Holder

The Rago Fabrication Relay Holder is a bolt-on engine-bay bracket for the Lexus GX 470 and the 2010–2024 Toyota 4Runner (5th Gen) that organizes up to three relays in the driver-side engine bay. The bracket ships with all hardware needed for installation and is finished in powder coated textured black.

Clean Wiring, No Fabrication Required

Routing power for auxiliary lighting, compressors, or other accessories means relays. Loose relays tucked behind factory harnesses create troubleshooting headaches later. The Rago Fabrication Relay Holder gives each relay a fixed, labeled position in the driver-side engine bay so wiring stays organized from the first install and stays that way through years of trail use and engine-bay heat cycles. Because the bracket is 100% bolt-on, no drilling or welding is required, and the bracket can be removed or repositioned without leaving permanent marks on the vehicle.

Built for LED Wiring Arrays

The relay holder is designed to fit most LED wiring arrays, making it a practical anchor point when wiring ditch lights, light bars, or other switched auxiliary circuits. Holding up to three relays in a single bracket keeps relay wiring consolidated rather than scattered across the engine bay, which simplifies tracing a circuit and speeds up any future modifications.

Powder Coat Finish for Long-Term Durability

The bracket is finished in a textured black powder coat. Powder coating bonds directly to the steel substrate and resists chipping, corrosion, and the heat and moisture cycles an engine bay sees over time, so the bracket holds its appearance without touch-up painting or periodic re-coating.

Features

• Holds up to three relays: organizes relay wiring in a single, fixed location in the driver-side engine bay
• 100% bolt-on installation: no drilling or welding; all mounting hardware included
• Fits most LED wiring arrays: compatible with common auxiliary lighting relay configurations
• Powder coated textured black: durable finish suited to engine-bay conditions
• Patent No. US 787,918 S

Specifications

Who This Is For and Isn't

This relay holder suits GX 470 and 2010–2024 Toyota 4Runner owners who are adding auxiliary lighting or other relay-switched accessories and want a clean, bolt-on solution for organizing up to three relays in the engine bay without permanent modifications.

This bracket is not compatible with vehicles other than the Lexus GX 470 and the 5th Gen Toyota 4Runner (2010–2024). Relays are not included with the bracket.

WARNING: This product can expose you to chemicals including silica, crystalline, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.

Common Questions

Which vehicles does this relay holder fit?

The Rago Fabrication Relay Holder is designed specifically for the Lexus GX 470 and the Toyota 4Runner 5th Gen (2010–2024). It is not a universal bracket and is not confirmed to fit other vehicles.

How many relays does the bracket hold?

The relay holder organizes up to three relays. It is designed to fit most LED wiring arrays, making it well suited for auxiliary lighting setups that use individual relays for each circuit.

Is any drilling or cutting required to install this bracket?

No. The Rago Fabrication Relay Holder is 100% bolt-on. All mounting hardware needed for installation is included in the box, and no permanent modifications to the vehicle are required.

Where in the engine bay does the bracket mount?

The relay holder mounts on the driver side of the engine bay. This location keeps relay wiring consolidated near common auxiliary circuit routing points for ditch lights, light bars, and similar accessories.

Are relays included with the bracket?

Relays are not included. The Rago Fabrication Relay Holder is the mounting bracket only; relays for your specific wiring array are sourced and installed separately.