DV8 Offroad Universal MOLLE Panel Rotopax Mount

The DV8 Offroad Universal MOLLE Panel Rotopax Mount is a 3mm steel plate that gives any MOLLE panel with a 4×3-inch bolt pattern a dedicated, low-profile mounting point for a Rotopax-style fuel or water tank. It works with DV8 MOLLE panels and any other brand built to that same 4×3-inch spacing, and it installs in either vertical or horizontal orientation without cutting.

Stays Flat, Stays Secure

The low-profile design holds a Rotopax tank tight against the panel surface rather than standing it off on a bracket. That matters on a truck bed panel or roof rack where a protruding mount can catch gear, snag straps, or shift the tank's center of gravity enough to stress the panel over rough terrain. Keeping the tank close to the panel distributes the load more evenly and reduces the lever arm acting on the four M6 mounting bolts.

Bolt-On in About 30 Minutes

Installation requires no cutting. The mount attaches with four included M6 bolts through the panel's existing 4×3-inch MOLLE spacing. The ability to orient the plate vertically or horizontally means it adapts to whatever space is available on a truck bed panel, interior wall, trailer, or roof rack without requiring a separate bracket or adapter. DV8 states installation takes approximately 30 minutes.

Features

• Universal MOLLE compatibility: fits DV8 and other MOLLE panels using a 4×3-inch bolt pattern
• Tank size flexibility: accepts any size Rotopax-style tank where panel space allows
• Dual orientation: mounts vertically or horizontally to suit available space
• 3mm steel construction: finished in micro-texture black powder coat
• Hardware included: four M6 bolts for a secure, no-cut bolt-on installation

Specifications

Who This Is For and Isn't

This mount suits overlanders, truck campers, and off-road builders who want to add a Rotopax-style fuel or water tank to an existing MOLLE panel on a truck bed, roof rack, trailer, or interior wall without drilling new holes or fabricating a custom bracket.

This mount does not fit MOLLE panels with a bolt pattern other than 4×3 inches. A Rotopax tank is not included and must be purchased separately. The mount does not include the MOLLE panel itself.

Common Questions

Which MOLLE panels is this mount compatible with?

The DV8 Offroad Universal MOLLE Panel Rotopax Mount fits any MOLLE panel built to a 4×3-inch bolt pattern, including DV8's own MOLLE panels and panels from other brands that use the same spacing. Panels with a different bolt pattern are not compatible.

Does this mount include a Rotopax tank?

No. The DV8 Offroad Universal MOLLE Panel Rotopax Mount is a mounting plate only. A Rotopax-style fuel or water tank is not included and must be sourced separately.

What size Rotopax tanks will this mount accept?

The DV8 Offroad Universal MOLLE Panel Rotopax Mount accepts any size Rotopax-style tank, subject to the available space on the panel where the mount is installed. Tank size is not restricted by the mount itself.

Can the mount be installed in different orientations?

Yes. The DV8 Offroad Universal MOLLE Panel Rotopax Mount can be installed vertically or horizontally, allowing it to fit whatever space is available on a truck bed panel, roof rack, trailer, or interior MOLLE setup.

What tools and hardware are needed for installation?

The DV8 Offroad Universal MOLLE Panel Rotopax Mount includes four M6 bolts and requires no cutting. Installation takes approximately 30 minutes. No additional hardware is listed as required beyond what is included.

WARNING: This product can expose you to chemicals including lead and lead compounds, DEHP, and bisphenol A (BPA), which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.